The church with custom plastic wristbands design should pay attention to what|wristband maker online
sy to get dirty after a long time. We can do something to clean white rubber wristbands:
1. We should first soak the dry cloth in water and wash it once. Then we can fully screw the water and dry it for 9 minutes with a hairdryer. We should clean both inside and outside the white rubber wristbands.
2. If there is dirt and dust on the white rubber wristbands, we can use a small toothbrush to stick some toothpaste to clewristband maker onlinean it. If there is grease stain, use toothbrush to stick it.
3. If there is a sticky stain on the wristband such as glue, use a cotton swab to stick on a little wind oil essence and apply it evenly.Material is cleaned with a small toothbrush, so that stubborn stains can be removed.
4. Finally, we can use a dry cloth to dry the ring. Dry with a blower and cold air. But we must remember do not use hot air for hair dryer, it will be damaged by silicone material.
Debossed colorfilled silicone wristband. This is a kind of wristband debossed and filled with colors. It has a debossed effect on the surface of wristband .The important difference from a normal plain wristband is that we make onewristband maker online mould for every design to make it debossed engraving. When it is extruded the silicone , the logo will be on the wristband. Finally we will fill it with the silicone based ink which is long lasting. we can personalize the wristband size as well. The normal size is 202mm length for adult, 190mm for women, 180mm for youth and 150mm for child. The width can be 6mm, 12mm, 15mm, 19mm or 25mm. If these not fit you, then you probably need to pay extra for certain size. There are 4 styles mainly. They are solid, swirled, segmented and glow.
personalized-plastic-braceletspersonalized-memory-bracelet customer can provide the CDR or AI file. If not , we designer can make it according to customer’s request for free.
2 make the mould
The mould is made by the artwork that is confirmed by customer. A mould is made from copper usually. It is a necessary step to start production.
3 Color and rubber mixing
This is the step to prepare the raw material of the bracelet. We have to make the color as the pantone color customer wants.
Commonly 5.5g per bracelet.
5 start production
Set the mould on the machine and warm up to needed tempreture. 15k pcs bracelets can be done in 1 day by 1 machine.
6 edge cutting
Use the machine to cut the extra part of the bracelet and divice the bands made by one mould.
7 quality inspection
The defective must be picked out before packing.
8 packing and dilivery
The bulk packing is 100pcs/ bag, 2500pcs/ctn. There can be individually wrapped if customer request. We have the confirm the dilivery details before dispatching.